setting up my dd wrt v24 as a client bridge

You don't need to worry about the primary router as long as you set your CB to the SAME subnet. The router you are configuring is the Client Bridge (CB) router. The router that you are trying to connect to is the primary router. In this case, use Repeater Bridge - which provides a bridge to both wired clients and another AP extended for more potential wireless clients, all of which will be bridged through the Repeater Bridge device. MIMO radios, Client Bridge may not exist in the list of wireless modes. If CB will not work on your hardware, try Client Mode instead.Īlso note that on newer hardware and dd-wrt versions, e.g. For example, the 2.4GHz radio can a CB while the 5GHz is an AP, or vice versa.Ĭlient Bridge with dd-wrt SP1 won't work. The other radio(s) would normally be set as AP. If using a multi-band router, do not set more than one band to CB.All devices connections, besides the primary router, MUST be wired to the CB router.

CB is a wireless connection ( NOT wired) between two routers only. See Linking Routers for a description of each of the modes.Ĭlient Bridge (CB) extends a wired LAN using a wireless connection, as opposed to an Access Point that extends the Wireless LAN (WLAN) using a wired connection. It will cause connection problems for more than a single client. It is by design a hack and not a true transparent bridge like WDS. Client Bridge will never be as stable as any of those modes. Only use this or Repeater Bridge mode if all of the others are unsuitable: WDS, Client, Repeater, or AP. Wiki Path: DD-WRT Wiki Main / Tutorials / Linking Routers / Client Bridged

Setting up my dd wrt v24 as a client bridge